Vibratory Finishing Machine Manufacturers Share The Precautions For Using Vibration Motors (Automobiles & Vehicles - Motorcycles)

Hot-Web-Ads > Automobiles & Vehicles > Motorcycles

Item ID 13476162 in Category: Automobiles & Vehicles - Motorcycles

Vibratory Finishing Machine Manufacturers Share The Precautions For Using Vibration Motors


Free Online Advertising
Free Internet Web Site Advertising.


UK Free Classifieds
United Kingdom Free Ads Website.
100% Free Ad Posting.


Canada Free Ads
Popular Online Classifieds in Canada.
No Sign up, No Email Required to Post.

Today, the Vibratory Finishing Machine manufacturer shares the different mounting options and selection and installation issues for vibrating motors.

First, the bearing is broken, the bearing temperature is too high, and the raceway and rolling element are cracked and scarred.
1. If the lubricating oil is insufficient, aging or excessively added, the lubricating oil should not exceed 70% of the bearing cap and bearing volume.

2. There is iron powder and other impurities inside the lubricating oil, or the oil ring inside is stuck.

3. No installation is in place. For example, bearings, the bearing caps are not assembled, or too tight between them. Concentricity is not right, there is eccentricity causing damage.

4. The coupling level is not adjusted well. The chain or belt between the transmissions is too tight, and the shaft is subjected to load force impact deformation.

5. the bearing quality is not good, the bearing clearance is too small or too large.

6. the vibration motor start and stop frequency is too high, and the rigidity is too large, for some occasions should not be full pressure start, soft start will be better.

Second, the selection and installation problems
1. The level between the motor and the load is not adjusted well, causing a radial impact between the load and the motor.

2. The screws on the motor foot are not fixed, or the fixed shelf is not designed.

3. did not consider the load situation to select the type, some loads are frequently started and stopped, maybe only 1KW of power is calculated, the design considers the heat dissipation and the weakening problem, may need 3KW to use.

4. the line is wrong, for example, the star type is connected to the triangle type, and the triangle type is connected to the star type, which may cause the internal motor to overheat.

5. The load requires some special braking. The motor does not have a corresponding mechanical or electronic brake. It may not be able to release energy when parking.

6. the motor does not design some protection devices, such as overheating, overload, over temperature, lack of equal, these may occur during use, but because the protection is not in place, the motor will burn directly.

7. The wiring is wrong, or the reverse is reversed, or the wire is thinned, or the terminal wire is not pressed, resulting in excessive contact resistance.

8. If you use a photoelectric encoder or the like, you need to consider some dust protection and anti-collision protection.

9. If the drive is broken, it will cause high voltage or high current burnout on the motor side.

10. when the power supply, did not take into account the motor withstand voltage problems, such as 220 volts, using 380 volts into it.

11. some stepper motor and servo motor, can not be disassembled to replace the bearing or the like, otherwise it may lose magnetism or cause the encoder pole zero offset can not be used normally.

information about vibratory finishing machine : https://www.zhongyun-machine.com


Related Link: Click here to visit item owner's website (0 hit)

Target State: California
Target City : Huzhou
Last Update : May 07, 2019
Number of Views: 63
Item  Owner  : machineunique
Contact Email:
Contact Phone: (None)

Friendly reminder: Click here to read some tips.
Hot-Web-Ads > Automobiles & Vehicles > Motorcycles
 © 2019 Hot-Web-Ads.com
2019-12-11 (0.080 sec)